Honda Accord 2008 Manual page 1461

07/11/02 09:32:49 61TA0000_190_0040
Conventional Brake Components
Brake Hose Replacement (cont'd)
Rear
1. Remove the rear wheel.
2. Disconnect the brake line (A) from the brake hose
(B), then remove the brake hose clip (C).
＊０５
A
B
3. Remove the banjo bolt (A), and disconnect the
brake hose from the caliper.
＊０６
4. Remove the brake hose mounting bolt (B), then
remove the brake hose.
19-40
5. Install the brake hose (A) with the mounting bolt (B).
C
Replace.
6. Connect the brake hose to the caliper with the
banjo bolt (C) and new sealing washers (D).
7. Install a new brake hose clip (A) to the brake hose
(B) on the bracket, then connect the brake line (C).
Do not twist the brake hose.
B
8 x 1.25 mm
A
8. After installing the brake hoses, bleed the brake
system (see page 19-9).
9. Do the following checks:
• Check the brake hose and line joint for leaks, and
• Check the brake hose for interference and
10. Clean the mating surfaces of the brake disc and the
inside of the wheel, then install the rear wheel.
C
10 x 1.0 mm
35 N·m
(3.6 kgf·m, 26 lbf·ft)
B
tighten if necessary.
twisting.
B
8 x 1.25 mm
22 N·m
(2.2 kgf·m,
16 lbf·ft)
A
D
Replace.
C
10 x 1.0 mm
15 N·m
(1.5kgf·m,
11 lbf·ft)
A
Replace.
＊０７
＊０８