Honda Accord 2008 Manual page 1026

07/11/02 09:16:43 61TA0000_140_0183
14. Remove the shift solenoid harness (see page
14-226).
15. Check for continuity between shift solenoid
harness connector terminal No. 2 and the shift
solenoid valve B connector terminal.
＊０３
SHIFT SOLENOID
VALVE B
CONNECTOR
Wire side of
female terminals
Is there continuity?
YES
14-226), then go to step 16.
−
NO
14-226), then go to step 16.
SHIFT SOLENOID
HARNESS CONNECTOR
SH B (ORN)
Terminal side of
male terminals
− Replace shift solenoid valve B (see page
Replace the shift solenoid harness (see page
16. Reconnect all connectors.
17. Turn the ignition switch to ON (II).
18. Clear the DTC with the HDS.
19. Start the engine with the shift lever in P, and wait
for at least 1 second. Test-drive the vehicle in D
through 1st to 3rd gears, then drive in 3rd gear for
at least 1 second.
20. Check for Temporary DTCs or DTCs with the HDS.
Is DT C P097 7 indicated?
−
YES Check for poor connections or loose
terminals between shift solenoid valve B and the
PCM, then go to step 1.
NO − Go to step 21.
21. Monitor the OBD STATUS for P0977 in the DTCs
MENU with the HDS.
Does the HDS indicate PASSED?
−
YES Troubleshooting is complete. If any other
Temporary DTCs or DTCs were indicated in step 20,
go to the indicated DTC's troubleshooting.
NO − If the HDS indicates FAILED, check for poor
connections or loose terminals between shift
solenoid valve B and the PCM, then go to step 1. If
the HDS indicates NOT COMPLETED, go to step 19.
(cont'd)
14-181