Honda Accord 2008 Manual page 1648

07/11/02 09:31:05 61TA0000_200_0081
13. With a sponge, apply a light coat of glass primer
along the edge of the quarter glass (A) and the front
seal (B) as shown, then lightly wipe it off with gauze
or cheesecloth:
• With the printed dots (C) on the quarter glass as a
guide, apply the glass primer to the rear corner,
upper corner and lower corner portions of the
quarter glass.
• Do not apply body primer to the quarter glass,
and do not get body and glass primer sponges
mixed up.
• Never touch the primed surfaces with your hands.
If you do, the adhesive may not bond to the
quarter glass properly, causing a leak after the
quarter glass is installed.
• Keep water, dust, and abrasive materials away
from the primed surfaces.
＊０８
4.5 mm
(0.18 in.)
12 mm
(0.47 in.)
12 mm
(0.47 in.)
28.5 mm
(1.12 in.)
: Apply glass primer here.
C
A
A
22 mm
12 mm
(0.87 in.)
(0.47 in.)
A
A
14. With a sponge, carefully apply a light coat of body
primer to any exposed paint or metal around the
flange where new adhesive will be applied. Let the
primer dry for at least 10 minutes:
• Do not apply body primer to any remaining
original adhesive on the flange.
• Be careful not to mix up the body and glass
primer sponges.
• Never touch the primed surfaces with your hands.
: Apply body primer to any exposed paint as
shown.
20 mm
(0.79 in.)
A
6 mm
(0.24 in.)
B
15. Cut a ''V'' in the end of the nozzle (A) on the
adhesive cartridge as shown.
B
A
10 mm
(0.39 in.)
2 mm (0.08 in.)
13 mm (0.51 in.)
8 mm (0.31 in.)
＊０９
20 mm
(0.79 in.)
20 mm
(0.79 in.)
10 mm
(0.39 in.)
＊１０
(cont'd)
20-79