Honda Accord 2008 Manual page 868

07/11/02 08:46:21 61TA0000_140_0025
Symptom
Shift lever does
not operate
smoothly
Transmission does
not shift into P
Torque converter
clutch does not
disengage
Torque converter
clutch does not
operate smoothly
Probable Cause(s)
1. Transmission range switch
defective or out of adjustment
2. Shift cable broken or out of
adjustment
3. Connection between the shift
cable and transmission or body is
worn
1. Shift cable broken or out of
adjustment
2. Connection between the shift
cable and transmission or body is
worn
3. Park mechanism defective
1. Shift solenoid valve E defective
2. A/T clutch pressure control
solenoid valve A defective
3. Torque converter clutch piston
defective
4. Lock-up shift valve defective
5. Lock-up control valve defective
1. Shift solenoid valve E defective
2. A/T clutch pressure control
solenoid valve A defective
3. Torque converter clutch piston
defective
4. Torque converter check valve
defective
5. Lock-up shift valve defective
6. Lock-up control valve defective
Notes
• Check for a stored DTC, and check for loose
connectors.
• Inspect the transmission range switch for
operation.
• Check for a loose shift cable at the shift lever and
the transmission control shaft.
• Check for a loose shift cable at the shift lever and
the transmission control shaft.
• Check the park pawl spring installation and the
park lever spring installation. If installation is
incorrect, install the spring correctly. Make sure
that the park lever stop is not installed upside
down. Check the distance between the park pawl
shaft and the park lever roller pin. If the distance
is out of tolerance, adjust the distance with the
park lever stop.
• Check for a stored DTC, and check for loose
connectors.
• Inspect the solenoid valve filter/gasket and the
O-rings for wear and damage, and inspect the
solenoid valves for seizure.
• Replace the torque converter.
• Check for a stored DTC, and check for loose
connectors.
• Inspect the solenoid valve filter/gasket and the
O-rings for wear and damage, and inspect the
solenoid valves for seizure.
• Replace the torque converter.
(cont'd)
14-23