Honda Accord 2008 Manual page 1732

07/11/02 09:36:09 61TA0000_200_0165
3. Remove the screw (A).
＊０５
Fastener Locations
A
4. Pull out the side vent (B) to release the clips (C),
then remove the vent.
5. Install the side vent in the reverse order of removal,
and push the clips into place securely.
: Screw, 1
C : Clip, 3
C
C
B
Dashboard Center Vent Removal/
Installation
Special Tools Required
KTC trim tool set SOJATP2014
Available through the American Honda Tool and
Equipment Program; call 888-424-6857
With Navigation System
A
NOTE:
• Take care not to scratch the dashboard and its related
parts.
C • Use the appropriate tool from the KTC trim tool set to
avoid damage when removing components.
1. Apply protective tape (A) to the dashboard middle
pad beside both side edges of the dashboard center
vent (B). Pry up on the edge of the center vent with
the appropriate trim tool to detach the clips (C, D).
Fastener Locations
C : Clip, 2
A
B
ＴＡ０８ＡＮ１Ｊ２６２２０２１９２５１ＫＤＡＴ５０
D : Clip, 2
D
D
C
C
＊０１
A
(cont'd)
20-163 20-163