Honda Accord 2008 Manual page 1463

07/11/02 09:34:10 61TA0000_190_0042
Conventional Brake Components
Parking Brake Cable Replacement (cont'd)
NOTE:
• The parking brake cables must not be bent or
distorted. This will lead to stiff operation and
premature cable failure.
• Refer to the Exploded View as needed during this
procedure.
1. Release the parking brake lever fully.
2. Loosen the parking brake cable adjusting nut
(see page 19-8).
3. Remove the flange bolt (A) from the arm (B).
＊０２
C
4. Disconnect the parking brake cable from the lever
(C).
5. Remove the parking brake cable mounting
hardware, then remove the cable.
6. Install the parking brake cable in the reverse order
of removal, and note these items:
• Be careful not to bend or distort the cable.
• Make sure the clearance between the lower arm
B and parking brake cable is more than 5 mm
(3/16 in.).
• Adjust the parking brake (see page 19-8).
19-42
B
A
8 x 1.25 mm
22 N·m
(2.2 kgf·m,
16 lbf·ft)