Honda Accord 2008 Manual page 1603

07/11/02 09:29:11 61TA0000_200_0036
Doors
Front Door Weatherstrip Replacement
NOTE:
• Put on gloves to protect your hands.
• Take care not to scratch the door.
• Take care not to damage the front upper corner clip
(black) (4-door) and the rear upper corner clips (black)
in the weatherstrip because these clips are not able to
replace with new ones.
• Use a clip remover to remove the clips.
1. At the A-pillar, remove the door checker mounting
bolt (A).
2-door
＊０１
Fastener Locations
A
D
C
20-34
: Bolt, 1 B : Clip, 17
(Left: Pink)
(Right: Light Blue)
: Clip, 1 E
: Clip, 1 F : Clip, 1
(Black)
(White) (Orange)
D
F
B
G
A
8 x 1.25 mm
29 N·m
(3.0 kgf·m, 22 lbf·ft)
4-door
Fastener Locations
A
D
C : Clip, 5
(White)
C
G
H
E
2. Detach the clips (B, C, D, E, F), and release the door
weatherstrip (G) from the holder (H) of the door
sash, then remove the weatherstrip.
3. Install the weatherstrip in the reverse order of
removal, and note these items:
• If the clips are damaged or stress-whitened,
replace them with new ones.
• Make sure the weatherstrip is installed in the
holder securely.
• Apply medium strength liquid thread lock to the
door checker mounting bolt before installation.
• Check for water leaks (see step 8 on page 20-51).
ＴＡ０８Ａ００Ｊ１６１２６７２２０５１ＫＢＡＴ５０
: Bolt, 1 B : Clip, 16 C
(Left: Orange)
(Right: Purple)
: Clip, 2
(Black)
D
H
D
B
G
A
8 x 1.25 mm
29 N·m
(3.0 kgf·m, 22 lbf·ft)
＊０２
: Clip, 4
(Gray)
G