Honda Accord 2008 Manual page 1755

07/11/02 09:37:06 61TA0000_200_0188
Seats
Front Seat Recline Motor Replacement
Driver's Seat (10-way Power Seat)
SRS components are located in this area. Review the
SRS component locations, 2-door (see page 24-21),
4-door (see page 24-19) and the precautions and
procedures (see page 24-23) before doing repairs or
service.
NOTE: Put on gloves to protect your hands.
1. Remove the front seat (see page 20-180).
2. Remove the seat-back cover and pad:
• 2-door (see page 20-198)
• 4-door (see page 20-204)
3. 4-door driver's seat with lumbar support:
Disconnect and detach the lumbar support motor
connector (A), and detach the harness clip (B).
＊０１
4. Release the push nut (A) from the motor side end of
the connecting rod (B), gently tap on the motor side
of the connecting rod to remove it from the recline
motor (C) and both recline adjusters (D).
＊０２
5. Remove the rod cover (E) and the collars (F).
20-186
A
B
C
B
E
D
F
6. Remove the bolt, then remove the recline motor (A).
4-door driver's seat is shown; 2-door driver's seat is
similar.
Fastener Location
: Bolt, 1
7. Install the motor in the reverse order of removal,
and note these items:
• Replace the push nut with a new one. Make sure
the push nut is installed correctly.
• 4-door driver's seat: Make sure the lumbar
support motor connector is plugged in properly,
and push the harness clip into place securely.
• Apply medium strength liquid thread lock to the
mounting bolt before reinstallation.
A
D
F
ＴＡ０８ＡＥ４Ｊ４６１２７０４６５０１ＫＢＡＴ００
A
6 x 1.0 mm
9.8 N·m
(1.0 kgf·m, 7.2 lbf·ft)
＊０３