Honda Accord 2008 Manual page 1669

07/11/02 09:32:25 61TA0000_200_0102
Interior Trim
Trim Removal/Installation - Door Areas (cont'd)
Passenger's side
＊０４
Fastener Locations
: Clip, 2
(Gray)
B
6. Pull out the front door opening seal (A) from the
trim hooks (B) and around the front door opening
flange, then remove the seal.
＊０５
7. Install the trim in the reverse order of removal, and
note these items:
• If the clips are damaged or stress-whitened,
replace them with new ones.
• Push the clips, the hooks, and the tabs into place
securely.
• Driver's side: Before tightening the opener
mounting bolt, position the front door sill trim
against the opener firmly by screwing the trim
onto the opener.
20-100 20-100
C
C
D
A
B
A
Special Tools Required
KTC trim tool set SOJATP2014
Available through the American Honda Tool and
Equipment Program; call 888-424-6857
Rear Door Sill Area
NOTE:
• Put on gloves to protect your hands.
• Take care not to bend or scratch the trim and the
panels.
• Use the appropriate tool from the KTC trim tool set to
avoid damage when removing components.
1. Remove the rear seat cushion (see page 20-224).
2. Detach the hooks (A) and the tab (B) from the
B-pillar lower trim (C), and pull the rear door sill
trim (D) up by hand to detach the clips (E, F), then
remove it from the rear door opening seal (G).
Fastener Locations
E : Clip, 3 F : Clip, 1
(Gray) (Green)
D
G
F
E
ＴＡ０８ＡＢ４Ｊ２６２７３４０００００ＫＤＡＴ１２
D
D
E
A
E
I
B
C
＊２０