07/11/02 09:36:24 61TA0000_190_0107
11. Turn the ignition switch to LOCK (0).
12. Check for continuity between VSA modulator-
control unit 36P connector terminal No. 9 and
steering angle sensor 5P connector terminal No. 5.
*03
VSA MODULATOR-CONTROL UNIT 36P CONNECTOR
Is there continuity?
YES
NO
−
angle sensor and the VSA modulator-control
unit.
STEERING ANGLE SENSOR 5P CONNECTOR
Wire side of female terminals
SVCC (ORN)
SVCC (ORN)
Wire side of female terminals
−
Go to step 13.
Repair open in the wire between the steering
13. Reconnect all connectors.
14. Update the VSA modulator-control unit if it does
not have the latest software (see page 19-140). If
the unit already has the latest software, substitute a
known-good VSA modulator-control unit (see page
19-141).
15. Turn the ignition switch to LOCK (0), then turn it to
ON (II) again.
16. Check for DTCs with the HDS.
Is DT C 66-12 indicated?
−
YES
Check for loose terminals in the VSA
modulator-control unit 36P connector. If the VSA
modulator-control unit was updated, substitute a
known-good VSA modulator-control unit (see page
19-141), then retest. If the VSA modulator-control
unit was substituted, go to step 1.
NO
−
If the VSA modulator-control unit was
updated, troubleshooting is complete. If the VSA
modulator-control unit was substituted, replace the
original VSA modulator-control unit (see page
19-141). If any other DTCs are indicated, go to the
indicated DTCs troubleshooting.
19-107