Honda Accord 2008 Manual page 1521

07/11/02 09:35:42 61TA0000_190_0100
VSA System Components
DTC Troubleshooting (cont'd)
DTC 64-11:
Circuit Low Voltage
1. Turn the ignition switch to ON (II).
2. Clear the DTC with the HDS.
3. Turn the ignition switch to LOCK (0), then turn it to
ON (II) again.
4. Check for DTCs with the HDS.
Is DT C 64-11 indicated?
YES
NO −
time.
5. Turn the ignition switch to LOCK (0).
6. Disconnect the steering angle sensor 5P connector
(see page 19-137).
7. Disconnect the VSA modulator-control unit 36P
connector (see step 3 on page 19-142).
8. Check for continuity between steering angle sensor
5P connector terminal No. 5 and body ground.
＊０１
Is there continuity?
YES
between the steering angle sensor and the VSA
modulator-control unit.
−
NO
19-100
Steering Angle Sensor Power
−
Go to step 5.
Intermittent failure, the system is OK at this
STEERING ANGLE SENSOR 5P CONNECTOR
SVCC (ORN)
Wire side of female terminals
− Repair short to body ground in the wire
Go to step 9.
9. Reconnect all connectors.
10. Update the VSA modulator-control unit if it does
not have the latest software (see page 19-140). If
the unit already has the latest software, substitute a
known-good VSA modulator-control unit (see page
19-141).
11. Turn the ignition switch to LOCK (0), then turn it to
ON (II) again.
12. Check for DTCs with the HDS.
Is DT C 64-11 indicated?
−
YES Check for loose terminals in the VSA
modulator-control unit 36P connector. If the VSA
modulator-control unit was updated, substitute a
known-good VSA modulator-control unit (see page
19-141), then retest. If the VSA modulator-control
unit was substituted, go to step 1.
NO − If the VSA modulator-control unit was
updated, troubleshooting is complete. If the VSA
modulator-control unit was substituted, replace the
original VSA modulator-control unit (see page
19-141). If any other DTCs are indicated, go to the
indicated DTCs troubleshooting.
ＴＡ０８ＡＥ４Ｋ８０１０００Ｒ６４１１ＦＡＡＴ００