07/11/02 09:36:25 61TA0000_190_0111
18. Measure the voltage between brake pedal position
switch 4P connector terminal No. 1 and body
ground.
*04
BRAKE PEDAL POSITION SWITCH 4P CONNECTOR
Is there battery voltage?
YES
NO
−
(20 A) fuse in the under-hood fuse/relay box and
the brake pedal position switch.
RED
Wire side of female terminals
−
Go to step 19.
Repair open in the wire between the No. 10
19. Check for continuity between brake pedal position
switch 4P connector terminal No. 2 and ECM/PCM
connector A (49P) terminal No. 42.
ECM/PCM CONNECTOR A (49P)
Terminal side of female terminals
BKSW (LT GRN)
BRAKE PEDAL POSITION SWITCH 4P CONNECTOR
Wire side of female terminals
Is there continuity?
YES
−
Update the ECM/PCM if it does not have the
latest software (see page 11-231), or substitute a
known-good ECM/PCM (see page 11-7), then go to
step 1 and recheck. If the ECM/PCM was updated
and DTCs are not indicated, troubleshooting is
complete. If the ECM/PCM was substituted and
DTCs are not indicated, replace the original ECM/
PCM (see page 11-232).
−
NO
Repair open in the wire between the ECM/
PCM and the brake pedal position switch.
LT GRN
(cont'd)
19-111
*05