Honda Accord 2008 Manual page 1288

07/11/02 09:19:39 61TA0000_170_0022
22. Install the roll pin (A) into the slots between the
cam ring (B) and outer case (C), then push the roll
pin into the set hole.
＊１０
23. Install the rotor (A) in the cam ring (B).
＊１１
D
24. Set the 9 vanes (C) into the grooves in the rotor.
Make sure that the gold-colored ends (D) of the
vanes are in contact with the sliding surface of the
cam ring.
A
B
C
A
C
25. Install the snap ring (A).
A
26. Coat the new 13.0 mm O-rings (A) with power
steering fluid, and install them into the grooves in
the pump housing (B).
B
＊１２
＊１３
A
Replace.
B
(cont'd)
17-21