Honda Accord 2008 Manual page 1754

07/11/02 09:37:06 61TA0000_200_0187
12. Install the seat in the reverse order of removal, and
note these items:
• Apply medium strength liquid thread lock to the
seat mounting bolts before reinstallation.
• Tighten the seat mounting bolts to the specified
torque in the sequence shown. Slide the seat all
the way back and tighten
forward and tighten
shown; the passenger's seat is symmetrical.
• The triangle marks (A) on the anchor plate (B)
and the lower anchor (C) must face the same side.
Insert the anchor plate into the lower anchor, and
make sure that it is locked securely. Make sure
each connector is plugged in properly.
• Tighten the bolts by hand first, then tighten them
to specification with a torque wrench.
• Do the battery terminal reconnection procedure
(see page 22-89).
• Check for any DTCs that may have been set
during repairs, and clear them.
Seat mounting bolts tightening sequence
＊１９
Fastener Locations
: Bolt, 2
10 x 1.25 mm
41 N·m
(4.2 kgf·m,
30 lbf·ft)
and , then slide it
and . The driver's seat is
2-door passenger's front seat belt lower anchor
installation
A
B
＊２０
C
A
20-185