Honda Accord 2008 Manual page 1597

07/11/02 09:29:08 61TA0000_200_0030
Doors
Front Door Glass and Regulator Replacement (cont'd)
7. Disconnect the connector (A) from the regulator (B).
2-door
＊０７
Fastener Locations
C
B
6 x 1.0 mm
9.8 N·m (1.0 kgf·m, 7.2 lbf·ft)
4-door
＊０８
Fastener Locations
C
8. Remove the bolts (C), and loosen the bolts (D).
Release the hook (E), then remove the regulator
through the hole in the door.
20-28
: Bolt, 5 D
: Bolt, 1
(Black)
(Silver)
6 x 1.0 mm
9.8 N·m
(1.0 kgf·m, 7.2 lbf·ft)
C
D
C
C
C
C
: Bolt, 5 D : Bolt, 1
(Black)
(Silver)
6 x 1.0 mm
9.8 N·m
(1.0 kgf·m,
7.2 lbf·ft)
C
D
C
C
C
C
6 x 1.0 mm
9.8 N·m (1.0 kgf·m, 7.2 lbf·ft)
9. Apply multipurpose grease to all the sliding
surfaces of the regulator (A) where shown. 4-door
is shown; 2-door is similar.
A
E
A
10. Install the glass and regulator in the reverse order
of removal, and note these items:
• Roll the glass up and down to see if it moves
freely without binding.
• Make sure that there is no clearance between the
glass and glass run channel when the glass is
closed.
• Adjust the position of the glass as necessary
(see page 20-50).
• Do the power window control unit reset
procedure (see page 22-253).
• When reinstalling the door panel, make sure the
plastic cover is installed properly and sealed
around its outside perimeter to seal out water.
• Check for water leaks (see step 8 on page 20-51).
E
• Test-drive and check for wind noise and rattles.
• Make sure the power door locks, windows and
power mirror operate properly.
B
A
＊０９
A