Honda Accord 2008 Manual page 1674

07/11/02 09:32:27 61TA0000_200_0107
Special Tools Required
KTC trim tool set SOJATP2014
Available through the American Honda Tool and
Equipment Program; call 888-424-6857
B-pillar Upper Trim - 2-door
SRS components are located in this area. Review the
SRS component locations (see page 24-21) and the
precautions and procedures (see page 24-23) before
doing repairs or service.
NOTE:
• Put on gloves to protect your hands.
• Take care not to bend or scratch the trim and the
panels.
• Use the appropriate tool from the KTC trim tool set to
avoid damage when removing components.
1. Remove these items:
• Door sill trim (see page 20-97)
• Door opening seal, as needed (see step 6 on page
20-98)
• Front seat belt lower anchor bolt, driver's side
(see step 2 on page 24-5)
• Front seat belt lower anchor plate, passenger's
side (see step 2 on page 24-5)
• Rear side trim panel, as needed (see page
20-118)
2. Lower the coat hanger, then remove the screw (see
step 1 on page 20-110).
3. Pull down the roof portion of the C-pillar trim from
the B-pillar upper trim by detaching the hooks and
the clip (see step 5 on page 20-111).
4. Remove the B-pillar upper trim (A).
–1 Detach the lower hooks (B) and the lower clip
(C).
–2 Pull the bottom of the trim back to release the
upper pin (D) from the hole in the body.
–3 Detach the upper clip (E).
–4 Pull the trim down to release the upper hook
(F) from the hole in the body.
Fastener Locations
C
: Clip, 1 E : Clip, 1
(Green)
(Gray)
F
E
D
A
C
ＴＡ０８ＡＢ２Ｊ２６２７３４０００００ＫＤＡＴ４８
F
A
B
B
(cont'd)
20-105
＊０６