07/11/02 09:17:56 61TA0000_110_0352
Fuel Supply System
Fuel Pump Circuit Troubleshooting
If you suspect a problem with the fuel pump, check that
the fuel pump actually runs; when it is on, you will hear
some noise if you listen to the fuel fill port with the fuel
fill cap removed. The fuel pump should run for
2 seconds when the ignition switch is turned on. If the
fuel pump does not make noise, check as follows:
1. Turn the ignition switch to LOCK (0).
2. Remove the driver's dashboard lower cover
(see page 20-152).
3. Remove PGM-FI main relay 2 (FUEL PUMP) (A) in
the driver's under-dash fuse/relay box.
*01
A
4. Turn the ignition switch to ON (II).
11-352
5. Measure voltage between PGM-FI main relay 2
(FUEL PUMP) 4P connector terminal No. 4 and
body ground.
PGM-FI MAIN RELAY 2 (FUEL PUMP) 4P CONNECTOR
IGP
Terminal side of female terminals
Is there battery voltage?
−
YES
Go to step 13.
NO
−
Go to step 6.
6. Turn the ignition switch to LOCK (0).
7. Remove PGM-FI main relay 1 (A) from the under-
hood fuse/relay box.
A
TA08AE4A20326428302FAAT10
*02
*03