Clutch Wave-Plate Phase Difference Inspection - Honda Accord 2008 Manual

Hide thumbs Also See for Accord 2008:

Table of Contents

07/11/02 09:23:27 61TA0000_140_0364

Shafts and Clutches

Clutch Wave-plate Phase Difference Inspection

1. Place the clutch wave-plate (A) on a surface plate,

and set a dial indicator (B) on the wave-plate.

2. Find the bottom (C) of a phase difference of the

wave-plate, zero the dial indicator and make a

reference mark on the bottom of the wave-plate.

3. Rotate the wave-plate about 60-degrees apart from

the bottom while holding the wave-plate by its

circumference. The dial indicator should be at the

top (D) of a phase difference. Do not rotate the

wave-plate while holding its surface, always rotate

it with holding its circumference.

4. Read the dial indicator. The dial indicator reads the

phase difference (E) of the wave-plate between

bottom and top.

Standard Phase Difference:

1st Clutch: 0.15 0.25 mm (0.006 0.010 in.)

2nd Clutch: 0.1 0.2 mm (0.004 0.008 in.)

3rd Clutch: 0.1 0.2 mm (0.004 0.008 in.)

4th Clutch: 0.1 0.2 mm (0.004 0.008 in.)

5th Clutch: 0.1 0.2 mm (0.004 0.008 in.)

5. Rotate the wave-plate about 60-degrees. The dial

indicator should be at the bottom of a phase

difference (F and G), and zero the dial indicator.

6. Measure the phase difference at the other two tops

(H and I) of the wave-plate by following steps 3 thru

7. If two of the three measurements are within the

standard, the wave-plate is OK. If two of the three

measurements are out of the standard, replace the

ＴＡ０８ＡＥＢＥ１０４１１２１２２３１ＭＡＡＴ００

Table of Contents