Honda Accord 2008 Manual page 1065

07/11/02 09:18:06 61TA0000_140_0222
Automatic Transmission
Pressure Test (cont'd)
20. Connect the A/T oil pressure gauge to the 3rd
clutch pressure inspection port (D) and the 5th
clutch pressure inspection port (F).
＊０５
D
F
21. Connect the A/T oil pressure gauge to the 4th clutch
pressure inspection port (E).
＊０６
22. Start the engine with the shift lever in P, while
pressing the brake pedal.
23. Shift to D, and release the brake pedal; the
transmission is in 1st gear.
24. Press the accelerator pedal to increase the engine
speed to 2,500 rpm, then shift to 2nd gear.
25. Release the accelerator pedal slowly to close the
throttle over 5 seconds; the engine speed
decreases to 1,000 rpm with the transmission in
2nd gear.
14-220
26. Press the accelerator pedal very slowly to increase
the engine speed to 2,000 rpm over 5 seconds, and
hold the accelerator. Shift to 3rd gear, and measure
the 3rd clutch pressure at the 3rd clutch pressure
inspection port (D) while holding engine speed at
2,000 rpm.
27. Shift to 4th gear, and measure the 4th clutch
pressure at the 4th clutch pressure inspection port
(E).
28. Shift to 5th gear, and measure 5th clutch pressure
at the 5th clutch pressure inspection port (F) while
holding engine speed at 2,000 rpm.
Pressure
3rd clutch
(D)
4th clutch
(E)
5th clutch
(F)
29. Bring the engine back to an idle, then apply the
E
brake pedal to stop the wheels from rotating.
30. Shift to R, then release the brake pedal. Raise the
engine speed to 2,000 rpm, and measure 4th clutch
pressure at the 4th clutch pressure inspection port
(E).
Pressure
4th clutch
(E) in R
31. Turn the engine off, then disconnect the A/T oil
pressure gauges from the 3rd, 4th, and 5th clutch
pressure inspection ports.
32. Install the sealing bolts in the 3rd, 4th, and 5th
clutch pressure inspection ports with new sealing
washers, and tighten the sealing bolts to 18 N·m
(1.8 kgf·m, 13 lbf·ft). Do not reuse the old sealing
washers.
Fluid Pressure
Standard Service Limit
917 995 kPa − 868 kPa
2
(9.35 10.15 kgf/cm , − (8.85 kgf/cm ,
133 144 psi) − 126 psi)
Fluid Pressure
Standard Service Limit
917 995 kPa − 868 kPa
2
(9.35 10.15 kgf/cm , − (8.85 kgf/cm ,
133 144 psi) − 126 psi)
2
2