Honda Accord 2008 Manual page 1222

Hide thumbs Also See for Accord 2008:

Table of Contents

07/11/02 09:23:37 61TA0000_140_0379

NOTE: Refer to the Exploded View as needed during the

following procedure.

1. Install the differential assembly in the torque

converter housing.

2. Install the baffle plate on the servo body.

3. Assemble the mainshaft, the countershaft, and the

secondary shaft.

4. Join the mainshaft subassembly (A), the

countershaft subassembly (B), and the secondary

shaft subassembly (C) together. Then install them

in the torque converter housing. Do not bump the

countershaft on the baffle plate (D).

5. Make sure the countershaft subassembly and the

differential assembly are clear of the baffle plate

6. If the detent arm was removed, install the detent

arm (A) with the arm collar (B) on the servo body

(C), and install a new lock washer (D) by aligning its

cutout (E) with the projection (F) of the servo body.

Install and tighten the bolt, then bend the lock tab

of the lock washer against the bolt head.

12 N·m (1.2 kgf·m, 8.7 lbf·ft)

Chapters

Table of Contents