Honda Accord 2008 Manual page 813

Hide thumbs Also See for Accord 2008:

Table of Contents

07/11/02 09:24:40 61TA0000_130_0040

Manual Transmission

Mainshaft Reassembly (cont'd)

Special Tools Required

• Driver, 40 mm I.D. 07746-0030100

• Attachment, 30 mm I.D. 07746-0030300

NOTE: Refer to the Exploded View, as needed, during

this procedure.

1. Clean all the parts in solvent, dry them, and apply

MTF to all contact surfaces except the 3rd/4th and

5th synchro hubs.

2. Install the needle bearing and 3rd gear on the

3. Install the double cone synchro assembly (A) by

aligning the synchro cone fingers (B) with the holes

in 3rd gear (C), then install the synchro spring (D).

4. Install the 3rd/4th synchro hub (A) by aligning the

synchro ring fingers (B) with the grooves in the

3rd/4th synchro hub (C).

5. Install the 3rd/4th synchro hub (A) using the 40 mm

I.D. driver.

07746-0030100

6. Install the 3rd/4th synchro sleeve (A) by aligning

the stops (B) of the 3rd/4th synchro sleeve and 3rd/

4th synchro hub. After installing, check the

operation of the 3rd/4th synchro hub set.

Chapters

Table of Contents