Honda Accord 2008 Manual page 1264

07/11/02 09:17:31 61TA0000_160_0025
Special Tools Required
• Oil seal driver 07GAD-PH70201
• Attachment, 52 x 55 mm 07746-0010400
• Attachment, 35 mm I.D. 07746-0030400
• Driver 07749-0010000
• Installer attachment 07MAD-PR90100
NOTE: Refer to the Exploded View, as needed, during
this procedure.
1. Clean the disassembled parts with solvent, and dry
them with compressed air.
NOTE: Do not wash the rubber parts with solvent.
2. Press the intermediate shaft bearing (A) into the
bearing support (B) using the 52 x 55 mm
attachment (C), the driver (D), and a press.
＊０２
B
3. Install the internal snap ring in the groove of the
bearing support.
＊０３
PRESS
D
07749-0010000 C
07746-0010400
4. Press the intermediate shaft (A) into the new shaft
bearing (B) using the 35 mm I.D. attachment (C) and
a press.
5. Install the external snap ring (A) in the groove of
the intermediate shaft (B).
A
PRESS
A
B
C
07746-0030400
B
A
(cont'd)
16-25
＊０４
＊０５