Honda Accord 2008 Manual page 970

07/11/02 08:48:34 61TA0000_140_0127
10. Monitor the OBD STATUS for P0734 in the DTCs
MENU with the HDS.
Does the HDS indicate PASSED?
YES − Troubleshooting is complete. If any other
Temporary DTCs or DTCs were indicated in step 9,
go to the indicated DTC's troubleshooting.
−
NO If the HDS indicates FAILED, repair the 4th
clutch, or replace the transmission. If the HDS
indicates NOT COMPLETED, go to step 8.
11. Test-drive the vehicle in 4th gear with the shift lever
in D at speeds over 7 mph (12 km/h) with engine
speed above 1,000 rpm for at least 12 seconds.
12. Check for Temporary DTCs or DTCs with the HDS.
Is DT C P07 34 indicated?
−
YES Check for poor connections or loose
terminals between the input shaft (mainshaft)
speed sensor and the output shaft (countershaft)
speed sensor and the PCM, then go to step 4.
−
NO Go to step 13.
13. Monitor the OBD STATUS for P0734 in the DTCs
MENU with the HDS.
Does the HDS indicate PASSED?
−
YES Troubleshooting is complete. If any other
Temporary DTCs or DTCs were indicated in step 12,
go to the indicated DTC's troubleshooting.
NO − If the HDS indicates FAILED, check for poor
connections or loose terminals between the input
shaft (mainshaft) speed sensor and the output shaft
(countershaft) speed sensor and the PCM, then go
to step 4. If the HDS indicates NOT COMPLETED, go
to step 11.
14-125