Honda Accord 2008 Manual page 946

07/11/02 08:48:06 61TA0000_140_0103
22. Connect PCM connector B (49P).
23. Turn the ignition switch to ON (II).
24. Measure the voltage between input shaft
(mainshaft) speed sensor connector terminals
No. 2 and No. 3.
＊０６
Is there about 5 V ?
YES
−
NO
INPUT SHAFT (MAINSHAFT)
SPEED SENSOR CONNECTOR
NM (WHT/RED) SG2 (GRN/BLK)
Wire side of female terminals
− Go to step 28.
Go to step 25.
25. Turn the ignition switch to LOCK (0).
26. Disconnect PCM connector B (49P).
27. Check for continuity between PCM connector
terminal B18 and input shaft (mainshaft) speed
sensor connector terminal No. 2.
PCM CONNECTOR B (49P)
NM (WHT/RED)
Terminal side of
female terminals
Is there continuity?
YES − Go to step 38.
−
NO Repair open in the wire between PCM
connector terminal B18 and the input shaft
(mainshaft) speed sensor, then go to step 32.
28. Connect the input shaft (mainshaft) speed sensor
connector.
29. Clear the DTC with the HDS.
30. Start the engine, disable the VSA by pressing the
VSA OFF switch, run the vehicle with the shift lever
in D, and hold the vehicle at speeds over 12 mph
(20 km/h) for at least 10 seconds. Slow down and
stop the wheels.
31. Monitor the OBD STATUS for P0716 or P0717 in the
DTCs MENU with the HDS.
Does the HDS indicate F AILED?
YES − Replace the input shaft (mainshaft) speed
sensor (see page 14-236), then go to step 32.
−
NO Go to step 38.
INPUT SHAFT
(MAINSHAFT)
SPEED SENSOR
CONNECTOR
NM
(WHT/RED)
Wire side of
female terminals
(cont'd)
14-101
＊０７