Honda Accord 2008 Manual page 1070

07/11/02 09:18:08 61TA0000_140_0227
18. Install new O-rings (two O-rings per shift solenoid
valve) (G) on the shift solenoid valves.
NOTE: A new shift solenoid valve comes with new
O-rings. If you install a new shift solenoid valve,
use the O-rings provided with it.
19. Install shift solenoid valve C (brown connector),
shift solenoid valve D (black connector), and shift
solenoid valve E (black connector) by holding the
shift solenoid valve body; make sure the mounting
bracket contacts the servo body.
NOTE: Do not hold the shift solenoid valve
connector to install the shift solenoid valve. Be sure
to hold the shift solenoid valve body.
20. Install shift solenoid valve A (brown connector) by
holding the shift solenoid valve body; make sure
the mounting bracket contacts the bracket of shift
solenoid valve D.
NOTE: Do not install shift solenoid valve A before
installing shift solenoid valve D. If shift solenoid
valve A is installed before installing shift solenoid
valve D, it may damage the hydraulic control
system.
21. Install shift solenoid valve B (brown connector) by
holding the shift solenoid valve body; make sure
the mounting bracket contacts the bracket of shift
solenoid valve E.
NOTE: Do not install shift solenoid valve B before
installing shift solenoid valve E. If shift solenoid
valve B is installed before installing shift solenoid
valve E, it may damage the hydraulic control
system.
22. Connect the shift solenoid harness terminals to the
shift solenoid valves:
• RED wire connector to shift solenoid valve E.
• GRN wire connector to shift solenoid valve C.
• ORN wire connector to shift solenoid valve B.
• BLU wire connector to shift solenoid valve A.
• YEL, WHT, WHT wire connector to shift solenoid
valve D.
23. Install a new gasket, the dowel pins, and the shift
solenoid valve cover.
24. Refill the transmission with ATF (see step 4 on page
14-242).
25. Install the splash shield.
14-225