Servo Body Disassembly, Inspection, And Reassembly - Honda Accord 2008 Manual

07/11/02 09:22:18 61TA0000_140_0339

Servo Body Disassembly, Inspection, and Reassembly

1. Clean all parts thoroughly in solvent, and dry them with compressed air. Blow out all passages.
2. Inspect the valve body for scoring and damage.
3. Check shift valve D for free movement. If it fails to slide freely, refer to the valve body repair procedure (see page
14-332).
4. When removing and installing the shift solenoid valves, refer to the shift solenoid valves removal and installation
(see page 14-338).
5. Coat all parts with ATF during assembly.
6. Replace the O-rings with new ones.
＊０１
SPRING SPECIFICATIONS
A
B
C
D
E
F
ＴＡ０８ＡＥＢＥ１０４８０１５４５０１ＭＥＡＴ００
2ND ACCUMULATOR PISTON
C
B
4TH ACCUMULATOR PISTON
O-RING
Replace.
A
SPRING SEAT
Springs
Shift valve D spring
4th accumulator spring B
4th accumulator spring A
2nd accumulator spring B
2nd accumulator spring A
5th accumulator spring
E
D
O-RING
Replace.
SHIFT VALVE D
SERVO VALVE/SHIFT FORK SHAFT
O-RING
Replace.
Standard (New)-Unit: mm (in.)
Wire Diameter
0.8 (0.031) 5.6 (0.220)
2.3 (0.091) 12.2 (0.480)
2.4 (0.094) 18.6 (0.732)
2.1 (0.083) 10.8 (0.425)
2.1 (0.083) 16.6 (0.654)
2.5 (0.098) 14.6 (0.575)
6 x 1.0 mm
12 N·m (1.2 kgf·m, 8.7 lbf·ft)
ACCUMULATOR COVER
F
5TH ACCUMULATOR PISTON
O-RING
Replace.
SERVO BODY
O.D. Free Length No. of Coils
28.1 (1.106)
31.5 (1.240)
49.0 (1.929)
34.0 (1.339)
48.7 (1.917)
29.9 (1.177)
15.9
6.6
7.1
8.2
8.4
4.9
14-337