Honda Accord 2008 Manual page 1213

Hide thumbs Also See for Accord 2008:

Table of Contents

07/11/02 09:23:31 61TA0000_140_0370

Shafts and Clutches

1st, 2nd, and 3rd Clutch Reassembly (cont'd)

5. Install the clutch spring compressor attachment

and the clutch spring compressor bolt assembly.

6. Set the clutch spring compressor attachment (A) on

the spring retainer (B) so that it compresses the

clutch return spring (C).

NOTE: Coat the circumference of the spring

retainer and areas where the spring retainer

contacts the clutch piston with ATF before

installation.

7. Compress the return spring carefully until the snap

07LAE-PX40100

07LAE-PX40100 or

07HAE-PL50100

07GAE-PG40200 or

07GAE-PG4020A

8. Install the snap ring using snap ring pliers.

9. Remove the clutch spring compressor attachments

ring can be installed. Check that the spring retainer

(A) is properly installed on the clutch hub (B). If

improperly installed, change the position of the

spring compressor attachment and the spring

NOTE: Insert the spring retainer so it can be

adjusted (center of tolerance) to prevent damaging

the spring retainer oil seal.

and the clutch spring compressor bolt assembly.

Chapters

Table of Contents