Honda Accord 2008 Manual page 940

07/11/02 08:47:46 61TA0000_140_0097
DTC P0713:
Circuit
NOTE:
• Before you troubleshoot, record all freeze data and
any on-board snapshot with the HDS, and review
General Troubleshooting Information (see page 14-4).
• This code is caused by an electrical circuit problem
and cannot be caused by a mechanical problem in the
transmission.
1. Turn the ignition switch to ON (II).
2. Check the ATF Temp Sensor voltage in the Data List
with the HDS.
Does the AT F T emp Sensor voltage exceed
4.93 V ?
YES
−
NO
time. Check for poor connections or loose terminals
between the ATF temperature sensor and the
PCM.
3. Turn the ignition switch to LOCK (0).
4. Disconnect the shift solenoid wire harness
connector.
5. Connect shift solenoid wire harness connector
terminals No. 6 and No. 7 with a jumper wire.
＊０１
SHIFT SOLENOID WIRE HARNESS CONNECTOR
6. Turn the ignition switch to ON (II).
Open in ATF Temperature Sensor
− Go to step 3.
Intermittent failure, the system is OK at this
ATFT (RED/YEL) SG2 (GRN/BLK)
JUMPER WIRE
Wire side of female terminals
7. Check the ATF Temp Sensor voltage in the Data List
with the HDS.
Does the AT F T emp Sensor voltage exceed
4.93 V ?
YES − Go to step 8.
−
NO Replace the ATF temperature sensor
(see page 14-239), then go to step 21.
8. Turn the ignition switch to LOCK (0).
9. Remove the jumper wire from the shift solenoid
wire harness connector.
10. Turn the ignition switch to ON (II).
11. Measure the voltage between shift solenoid wire
harness connector terminal No. 6 and body ground.
SHIFT SOLENOID WIRE HARNESS CONNECTOR
ATFT (RED/YEL)
Wire side of female terminals
Is there about 5 V ?
YES − Go to step 12.
−
NO Go to step 17.
ＴＡ０８ＡＥＢＫ７７１０００９０７１３ＦＡＡＴ００
＊０２
(cont'd)
14-95