Honda Accord 2008 Manual page 1442

07/11/02 09:32:40 61TA0000_190_0021
Thickness and Parallelism
1. Raise the front of the vehicle, and support it with
safety stands in the proper locations (see page 1-9).
2. Remove the front wheels.
3. Remove the brake pads: NISSIN type (see page
19-13), AKEBONO type (see page 19-17).
4. Using a micrometer, measure the brake disc
thickness at eight points, about 45 ° apart and
10 mm (3/8 in.) in from the outer edge of the brake
disc. Replace the brake disc if the smallest
measurement is less than the max. refinishing limit.
Brake disc thickness:
Standard:
Max. refinishing limit:
Brake disc parallelism: 0.015 mm (0.0006 in.) max.
NOTE: This is the maximum allowable difference
between the thickness measurements.
＊０２
NISSIN type: 27.9 28.1 mm (1.10 1.11 in.) −
AKEBONO type: 22.9 23.1 mm (0.90 0.91 in.) −
NISSIN type: 26.0 mm (1.02 in.)
AKEBONO type: 21.0 mm (0.83 in.)
10 mm
(3/8 in.)
5. If the brake disc is beyond the service limit for
parallelism, refinish the brake disc with a
commercially available on-car brake lathe.
NOTE: If the brake disc is beyond the service limit
for refinishing, replace it (see page 19-22).
6. Clean the mating surfaces of the brake disc and the
inside of the wheel, then install the front wheels.
−
−
19-21