07/11/02 09:29:49 61TA0000_180_0085
TPMS Control Unit Replacement
NOTE: Make sure the TPMS control unit mounting
bracket is not bent or twisted as this may affect its
communication with the tire pressure sensors.
1. Turn the ignition switch to LOCK (0).
2. Remove the flange bolt (A), then remove the TPMS
control unit (B) with the bracket (C).
NOTE: The TPMS control unit is located over the
accelerator pedal module.
*01
3. Disconnect the TPMS control unit connector (D).
A
6 x 1.0 mm
9.8 N·m (1.0 kgf·m, 7.2 lbf·ft)
D
C
B
4. Remove the TPMS control unit (A) from the bracket
(B).
NOTE: While separating the TPMS control unit
from the bracket, release the hook (C) on the TPMS
control unit using a flat-tipped screwdriver (D), and
push it up to remove the bracket.
B
D
B
C
5. Install the TPMS control unit in the reverse order of
removal.
NOTE: Make sure the TPMS control unit is properly
installed. You will hear a click when the TPMS
control unit is securely mounted on the bracket.
6. Connect the HDS, and memorize the tire pressure
sensor IDs using the TPMS initializer tool (see page
18-60).
TA08AE4B54175159631KBAT00
*02
A
18-85