Honda Accord 2008 Manual page 1604

07/11/02 09:29:12 61TA0000_200_0037
Rear Door Panel Removal/Installation
Special Tools Required
• KTC trim tool set SOJATP2014
• Trim pad remover, Snap-on A 177A or equivalent,
commercially available
Available through the American Honda Tool and
Equipment Program; call 888-424-6857
4-door
NOTE:
• Take care not to scratch the door and related parts.
• Use the appropriate tool from the KTC trim tool set to
avoid damage when removing components.
1. Raise the glass fully.
2. Push on the bottom of the inner handle cap (A)
while pushing on the upper hook (B) with the
appropriate trim tool, then pull back the cap to
remove it.
＊０１
3. Remove the screws securing the inner handle (A).
＊０２
Fastener Locations
B
: Screw, 2
A
4. Pry up the notch (A) of the lid (B), then pull back the
lid, and remove the screw.
Fastener Location
: Screw, 1
5. Remove the door panel (A) with as little bending as
possible to avoid creasing or breaking it.
–1 Start at the bottom edge of the door panel,
release the clips with a commercially available
trim pad remover.
–2 Detach the upper clips.
–3 Starting at the rear, pull the door panel upward.
NOTE: The inner handle cable (B) and latch
cable (C) are connected to the inner handle (D).
Do not pull the door panel up too far, or these
cables will be damaged.
Fastener Locations
: Clip, 8
A
(Gray)
A
ＴＡ０８ＡＢ４Ｊ１６１６６２２１４０１ＫＤＡＴ００
A
B
C
D
B
(cont'd)
20-35
＊０３
＊０４