Honda Accord 2008 Manual page 1625

07/11/02 09:29:53 61TA0000_200_0058
Mirrors
Mirror Holder Replacement
NOTE: Put on gloves to protect your hands.
1. Carefully push on the top edge of the mirror holder
(A) by hand.
＊０１
2. Put a shop towel in the opening between the
bottom edge of the mirror holder and the mirror
housing (B) to prevent scratches. Insert a flat-tip
screwdriver wrapped with protective tape to the
guide notches (C) of the mirror holder, and detach
the bottom clips (D).
3. While heating the mirror holder (A) from the
opening between the mirror holder and the mirror
housing with a heat gun, carefully pull out the
bottom edge of the mirror holder to separate the
adhesive (B), and then release the side clips (C).
NOTE: Do not heat the resin-made parts too much
or you may damage them.
＊０２
4. Separate the mirror holder from the actuator (D) by
releasing the hooks (E). If equipped, disconnect the
mirror defogger connectors (F).
20-56
B
C
D
C
C B
E
D
5. Before reinstalling the mirror holder to the inner
holder (A) of the actuator, check the actuator rods
(B) and the actuator boots (C):
• If each rod is off the actuator hole, insert it
securely.
A
• Each rod should be covered with a boot. If not,
adjust the boot into the proper position.
C
6. If equipped, reconnect the mirror defogger
A
connectors.
C
7. Reattach the hooks of the mirror holder to the
actuator, then position the mirror holder on the
actuator. Carefully push on the clip portions of the
mirror holder until the mirror holder locks into
place.
F
8. Check the actuator operation.
ＴＡ０８Ａ００Ｊ３４３０００４４０２１ＫＢＡＴ００
A
OK NO GOOD
A
B
C
A
C
B
A
＊０３
A
C
B