Mainshaft Inspection - Honda Accord 2008 Manual

07/11/02 09:24:38 61TA0000_130_0037
3. Support 3rd gear (A) on steel blocks, and press the
mainshaft out of the 3rd/4th synchro hub (B).
NOTE: Do not use a jaw-type puller; it can damage
the gear teeth.
＊０３

Mainshaft Inspection

1. Inspect the gear and bearing contact areas for wear
and damage, then measure the mainshaft at points
A, B, C, D, and E. If any part of the mainshaft is less
than the service limit, replace it.
Standard:
A Ball bearing contact area
(transmission housing side):
27.987 28.000 mm (1.1019 1.1024 in.)
B Distance collar contact area:
B
31.984 32.000 mm (1.2594 1.2598 in.)
C Needle bearing contact area:
38.984 39.000 mm (1.5348 1.5354 in.)
A
D Ball bearing contact area (clutch housing side):
27.927 27.960 mm (1.0994 1.1007 in.)
E Bushing contact area:
20.80 20.85 mm (0.8189 0.8209 in.)
Service Limit:
A: 27.94 mm (1.100 in.)
B: 31.93 mm (1.257 in.)
C: 38.93 mm (1.533 in.)
D: 27.94 mm (1.100 in.)
E: 20.75 mm (0.817 in.)
E
ＴＡ０８ＡＥＡＥ３４１５０４０００００ＭＡＡＴ１０
− −
− −
− −
− −
− −
D
C
B
＊１０
A
(cont'd)
13-37 13-37