Honda Accord 2008 Manual page 1748

07/11/02 09:37:02 61TA0000_200_0181
Front Seat Active Head Restraint Inspection
NOTE: If the vehicle has been in a collision, always
inspect the active head restraint, even if they appear
reusable, by doing the following procedure.
1. Manual seat/manual height adjustable seat: Fold
the seat-back forward, then recline the seat-back to
the first lock position, and adjust the head restraint
to the highest position.
2. 10-way power seat: With the recline switch, move
the seat-back fully forward.
3. Apply masking tape on the top of the head restraint.
4. Make marks (A) on both sides at 255 mm (10.0 in.)
upward from the roots of the head restraint frame
(B) along the back of the head restraint (C) surface.
Make a center of these points as a datum point (D).
＊０１
A
D
A
C
(255 mm)
(10.0 in.)
B
5. Push the head restraint (A) forward, and check:
With a scale, measure the level amount of the head
restraint movement. The head restraint should
move more than 50 mm (2.0 in.) without resistance.
If it is less than 50 mm (2.0 in.), or the head restraint
doesn't move smoothly, replace the seat-back
frame:
• Driver's seat (see page 20-192).
• Passenger's seat:
– 2-door (see page 20- 195)
– 4-door (see page 20- 197)
(255 mm)
(10.0 in.)
ＴＡ０８Ａ００Ｊ４６１２７０３１２２１ＭＡＡＴ００
Above 50 mm (2.0 in.)
(Level)
A
20-179
＊０２