Honda Accord 2008 Manual page 1672

07/11/02 09:32:26 61TA0000_200_0105
4. Pull the A-pillar trim (A) by hand to detach the clips.
Pull the trim up from the dashboard (B), then
remove it.
＊０４
Fastener Locations
: Clip, 2
(Green)
A
B
5. If the side curtain airbag has been deployed,
replace the A-pillar trim with a new one (see page
24-203).
6. If the side curtain airbag has not been deployed,
check the A-pillar trim (A) and note the following:
• To prevent the side curtain airbags from
deploying improperly and possibly causing
injury, inspect the A-pillar trim and replace it if it
has any of these types of damage:
– Any cracks, deformations, or stress-whitened
areas in the A-pillar trim
– Any cracks or stress-whitening in the clip
seating surfaces (B)
• Remove the grommet (C) from the pin (D), and
discard the grommet because it was damaged
during removal.
• Replace the grommet with a new one.
• Do not install the grommet to the pin before
checking the overlap between the headliner and
the A-pillar trim.
• If the clips (E) are damaged or stress-whitened,
replace them with new ones.
C
B
A
B
D
E
(cont'd)
20-103
＊０５