Backlash Inspection; Differential Carrier, Final Driven Gear Replacement - Honda Accord 2008 Manual

07/11/02 09:25:36 61TA0000_130_0065

Backlash Inspection

1. Place the differential assembly on V-blocks (A), and
install the intermediate shaft (B) and the left
driveshaft (C).
＊０１
E
B
2. Measure the backlash of both pinion gears (D) with
a dial indicator (E). If the backlash is not within the
standard, replace the differential carrier.
Standard (New): 0.05 0.15 mm (0.002 0.006 in.)
ＴＡ０８ＡＡ７Ｅ３４１５０７１９６４２ＭＡＡＴ０１
D
A
− −
Differential Carrier, Final Driven
Gear Replacement
1. Loosen the bolts in a crisscross pattern in several
steps, then remove the bolts and the final driven
gear (A) from the differential carrier (B).
C
2. Install the final driven gear with the chamfer on the
inside diameter facing the carrier. Tighten the bolts
in a crisscross pattern in several steps.
ＴＡ０８ＡＡ７Ｅ３４１５０７２７００２ＫＢＡＴ０２
11 x 1.0 mm (10)
121 N·m
(12.3 kgf·m,
89 lbf·ft)
A
B
13-65 13-65
＊０１