Honda Accord 2008 Manual page 1228

07/11/02 09:24:06 61TA0000_140_0385
19. Install the ATF feed pipe (A) into the idler gear shaft,
and install the ATF lubrication pipe (B) into the
transmission housing.
＊０８
20. Install a new gasket (A) on the transmission
housing, and install the two dowel pins (B) and new
O-rings (C) over the top of the ATF feed pipes.
＊０９
E
28 N·m
(2.9 kgf·m,
21 lbf·ft)
H
6 x 1.0 mm
12 N·m
(1.2 kgf·m,
8.7 lbf·ft)
B
21. Install the end cover (D), and tighten the three
special bolts (E) and the 6 x 1.0 mm bolts (F)
(12 bolts).
22. Install the harness clamp bracket (G) on the end
cover with the bolt (H).
A
E
G
23. Move the selector control shaft (A) from the P
position to the N position by turning the selector
control shaft on the torque converter side.
NOTE: Do not squeeze the end of the selector
control shaft tips together when turning the shaft. If
the tips are squeezed together it will cause a faulty
B
shift position signal or position due to the play
between the selector control shaft and the
transmission range switch.
A
F
6 x 1.0 mm
12 N·m
(1.2 kgf·m,
24. Align the cutouts (A) on the rotary-frame with the
8.7 lbf·ft)
neutral positioning cutouts (B) on the transmission
range switch (C), then put a 2.0 mm (0.08 in.) feeler
gauge blade (D) in the cutouts to hold in the N
position.
D
NOTE: Be sure to use a 2.0 mm (0.08 in.) blade or
equivalent to hold the transmission range switch in
the N position.
C
A
C
B
D
A
14-383
＊１０
＊１１
(cont'd)