Honda Accord 2008 Manual page 1456

07/11/02 09:32:46 61TA0000_190_0035
9. Remove the brake disc flathead screws (A).
＊０５
10. Remove the brake disc (B) from the hub bearing
unit.
NOTE: If the brake disc is stuck to the hub bearing
unit, thread two 8 x 1.25 mm bolts (C) into the brake
disc to push it away from the hub bearing unit.
Turn each bolt 90 degrees at a time to prevent the
brake disc from binding.
11. Install the brake disc in the reverse order of
removal, and note these items:
• Do the parking brake adjustment (see page 19-8).
• Before installing the brake disc, clean the mating
surfaces of the hub bearing unit and the inside of
the brake disc.
12. After install the brake caliper, make sure the
clearance between the lower arm B and parking
brake cable is more than 5 mm (0.20 in.).
13. Clean the mating surfaces of the brake disc and the
inside of the wheel, then install the rear wheel.
B
A
6 x 1.0 mm
9.8 N·m
(1.0 kgf·m,
7.2 lbf·ft)
C
8 x 1.25 mm
19-35