Honda Accord 2008 Manual page 1581

07/11/02 09:28:31 61TA0000_200_0014
Doors
Front Door Panel Removal/Installation
Special Tools Required
• KTC trim tool set SOJATP2014
• Trim pad remover, Snap-on A 177A or equivalent,
commercially available
Available through the American Honda Tool and
Equipment Program; call 888-424-6857
2-door
NOTE:
• Take care not to scratch the door and related parts.
• Use the appropriate tool from the KTC trim tool set to
avoid damage when removing components.
1. Remove the tweeter cover (see page 20-55).
2. Raise the glass fully.
3. Push on the bottom of the inner handle cap (A)
while pushing on the upper hook (B) with the
appropriate trim tool, then pull back the cap to
remove it.
＊０１
4. Remove the screws (A, B) securing the inner handle
(C).
＊０２
Fastener Locations
A
20-12
B
: Screw, 2 B : Screw, 1
A
A
B
5. Remove the front pull pocket cap (A), and remove
the screw.
Fastener Location
: Screw, 1
6. Pry up the notch (A) of the front door panel cap (B),
then pull back the cap to detach the hooks (C), and
release the hooks (D), then remove the cap.
Fastener Location
: Screw, 1
A
A
C
C
B
7. Remove the screw, and disconnect the power
window switch connector (E) and the power mirror
switch connector (F).
ＴＡ０８ＡＢ２Ｊ１６１２６７２１４０１ＫＤＡＴ１０
A
E
F
C
D
＊０３
＊０４