Atf Replacement - Honda Accord 2008 Manual

07/11/02 09:18:40 61TA0000_140_0244
Automatic Transmission

ATF Replacement

NOTE: Keep all foreign particles out of the transmission.
1. Warm up the engine to normal operating
temperature (the radiator fan comes on).
2. Park the vehicle on level ground, and turn the
engine off.
3. Remove the drain plug (A), and drain the automatic
transmission fluid (ATF). Then reinstall the drain
plug with a new sealing washer (B).
NOTE: If ATF cooler cleaning is necessary, refer to
ATF cooler cleaning (see page 14-270).
＊０１
B
Replace.
14-242
A
18 x 1.5 mm
49 N·m
(5.0 kgf·m, 36 lbf·ft)
ＴＡ０８ＡＥＢＥ１０４０００１３００１ＫＢＡＴ００
4. Remove the dipstick, and refill the transmission
with the recommended fluid amount through the
dipstick hole until the level reaches between the
upper mark and the lower mark on the dipstick.
Always use Honda ATF-Z1 automatic transmission
fluid (ATF). Using a non-Honda ATF can affect shift
quality.
Automatic Transmission Fluid Capacity:
2.5 L (2.6 US qt) at change
6.5 L (6.9 US qt) at overhaul
5. Insert the dipstick (A) back into the transmission
with the letters ''ATF'' pointing toward the front of
the vehicle.
A
6. Check the ATF level (see page 14-241).
＊０２