Honda Accord 2008 Manual page 1316

07/11/02 09:20:20 61TA0000_170_0050
27. Remove the snap ring (A) and sleeve (B) from the
pinion shaft.
＊２１
28. Using a cutter or an equivalent tool, cut and
remove the four seal rings from the sleeve. Be
careful not to damage the edges of the sleeve
grooves and outer surface when removing the seal
rings.
＊２２
C
B
29. Using a cutter or an equivalent tool, cut the valve
seal ring (A) and O-ring (B) at the cutting groove
position (C) in the pinion shaft. Remove the valve
seal ring and O-ring. Be careful not to damage the
edges of the pinion shaft groove and outer surface
when removing the valve seal ring and O-ring.
A
Replace.
30. Remove the valve oil seal (A) and roller bearing (B)
out of the valve housing using a hydraulic press
and an appropriate size socket wrench.
31. Clean the disassembled parts with solvent, and dry
them with compressed air. Do not dip rubber parts
in the solvent.
C
B
Replace.
A
Replace.
A
Replace.
B
(cont'd)
17-49
＊２３
＊２４