Honda Accord 2008 Manual page 765

07/11/02 09:15:16 61TA0000_120_0014
Clutch
Slave Cylinder Replacement (cont'd)
3. Remove the roll pins (A). Disconnect the clutch line
(B), and remove the O-ring (C). Plug or wrap the
end of the clutch line with a clean shop towel to
prevent brake fluid from coming out.
＊０３
4. Install a new O-ring (A) on the clutch line (B), install
the clutch line in the slave cylinder (C), and install
the new roll pins (D).
＊０４
12-12
C
A
B
C
B
D
Replace.
A
Replace.
5. Pull back the boot (A), and apply M-77 assembly
paste (P/N 08798-9010) to the boot and slave
cylinder rod (B). Reinstall the boot.
8 x 1.25 mm
22 N·m
(2.2 kgf·m, 16 lbf·ft)
(P/N 08798-9002)
A
6 x 1.0 mm
B
9.8 N·m
(1.0 kgf·m, 7.2 lbf·ft)
(P/N 08798-9010)
6. Apply super high temp urea grease (P/N 08798-
9002) to the pushrod of the slave cylinder. Tighten
the slave cylinder mounting bolts to 22 N·m
(2.2 kgf·m, 16 lbf·ft)
7. Bleed the clutch hydraulic system (see page 12-6).
8. Check the clutch operation, and check for leaks.
9. Do the battery installation procedure (see page
22-90).
10. Test-drive the vehicle.
＊０５