Honda Accord 2008 Manual page 1033

07/11/02 09:16:45 61TA0000_140_0190
Automatic Transmission
DTC Troubleshooting (cont'd)
DTC P0982: Short in Shift Solenoid Valve D
Circuit
NOTE:
• Before you troubleshoot, record all freeze data and
any on-board snapshot with the HDS, and review
General Troubleshooting Information (see page 14-4).
• This code is caused by an electrical circuit problem
and cannot be caused by a mechanical problem in the
transmission.
1. Turn the ignition switch to ON (II).
2. Clear the DTC with the HDS.
3. Test-drive the vehicle in 2nd gear with the shift
lever in D for at least 1 second.
4. Check for Temporary DTCs or DTCs with the HDS.
Is DT C P0982 indicated?
YES − Go to step 8.
NO − Go to step 5.
5. Select Shift Solenoid Valve D in the Miscellaneous
Test Menu, and test shift solenoid valve D with the
HDS.
Is a clicking sound heard?
−
YES Go to step 6.
NO − Go to step 8.
6. Test-drive the vehicle in 2nd gear with the shift
lever in D for at least 1 second.
7. Monitor the OBD STATUS for P0982 in the DTCs
MENU with the HDS.
Does the HDS indicate F AILED?
−
YES Go to step 8.
NO − If the HDS indicates PASSED, intermittent
failure, the system is OK at this time. Check for
intermittent short to body ground in the wire
between shift solenoid valve D and the PCM. If the
HDS indicates NOT COMPLETED, go to step 5.
8. Turn the ignition switch to LOCK (0).
14-188
9. Jump the SCS line with the HDS.
10. Disconnect PCM connectors B (49P) and C (49P).
11. Measure the resistance between PCM connector
terminals B27 and C44.
PCM CONNECTORS
B (49P) C (49P)
SH D (GRN/RED)
Terminal side of female terminals
Is there less than 12 ?
YES − Go to step 12.
NO − Go to step 22.
12. Disconnect the shift solenoid harness connector.
13. Check for continuity between PCM connector
terminals B27 and C44.
PCM CONNECTORS
B (49P) C (49P)
SH D (GRN/RED)
Terminal side of female terminals
Is there continuity?
YES − Repair short to body ground in the wire
between PCM connector terminal B27 and the shift
solenoid harness connector, then go to step 16.
NO − Go to step 14.
ＴＡ０８ＡＥＢＫ７７１０００９０９８２ＦＡＡＴ００
LG1 (BRN/YEL)
LG1 (BRN/YEL)
＊０１
＊０２