A/T Clutch Pressure Control Solenoid - Honda Accord 2008 Manual

07/11/02 09:18:11 61TA0000_140_0234
Automatic Transmission
A/T Clutch Pressure Control Solenoid Valve B Test (cont'd)
10. Disconnect the A/T clutch pressure control solenoid
valve C connector, then remove A/T clutch pressure
control solenoid valve B and C.
＊０７
11. Remove the ATF joint pipes (A), the O-rings (D), and
the gasket (E).
12. Check the fluid passage of A/T clutch pressure
control solenoid valve B and C for contamination.
14-232
E
A
D
6 x 1.0 mm
12 N·m
(1.2 kgf·m, 8.7 lbf·ft)
13. Connect a jumper wire from the negative battery
terminal to A/T clutch pressure control solenoid
valve B connector terminal No. 2, and connect
another jumper wire from the positive battery
terminal to connector terminal No. 1. Make sure
A/T clutch pressure control solenoid valve B moves.
C
B
B
14. Disconnect one of the jumper wires, and check the
valve movement at the fluid passage in the valve
body mounting surface. If the valve binds or moves
sluggishly, or if the solenoid valve does not operate,
replace A/T clutch pressure control solenoid valve
B and C.
15. Clean the mounting surface and the fluid passage
of the solenoid valve body and the transmission
housing.
16. Install a new gasket on the transmission housing,
and install the ATF joint pipes. Install new O-rings
over the ATF joint pipes.
NOTE: Be sure to install a new gasket with the blue
side toward the transmission housing.
17. Install A/T clutch pressure control solenoid valve B
and C.
18. Check the connectors for rust, dirt, or oil, clean or
repair if necessary, then connect the connectors
securely.
19. Install the battery base.
20. Do the battery installation procedure (see page
22-90).
＊０８