Honda Accord 2008 Manual page 1636

07/11/02 09:30:23 61TA0000_200_0069
5. Before installing the rearview mirror harness cover
base (A), apply primer to the area where the
harness cover base will be applied to the inside
face of the windshield. Let the primer dry at least
10 minutes, then attach it to the windshield within
12 hours.
＊０２
＊０３
6. Attach the rearview mirror harness cover base with
adhesive tape (B) to the inside face of the
windshield as shown, then press the adhesive
portions into place securely.
7. Reinstall all remaining removed parts.
: Apply primer here.
7 mm
(0.28 in.)
76 mm
(2.99 in.)
8 mm
(0.31 in.)
B
A
6 mm
(0.24 in.)
Rear Window Replacement
NOTE:
• Put on gloves to protect your hands.
• Wear eye protection while cutting the glass adhesive
with a piano wire.
• Use seat covers to avoid damaging any surfaces.
• Do not damage the rear window defogger grid lines,
window antenna grid lines, and terminals.
1. Remove these items:
• Trunk lid
• C-pillar trim, both sides:
– 2-door (see page 20- 110)
– 4-door (see page 20- 115)
• Rear shelf (see page 20-119)
2. Disconnect the window antenna connectors (A) and
rear window defogger connectors (B). 4-door is
shown; 2-door is similar.
B
3. If the old rear window will be reinstalled, make
alignment marks across the glass and the body
with a grease pencil.
ＴＡ０８Ａ００Ｊ５４４０００５０４６１ＫＢＡＴ００
A
(cont'd)
20-67 20-67
＊０１