07/11/02 08:48:08 61TA0000_140_0116
Automatic Transmission
DTC Troubleshooting (cont'd)
14. Connect PCM connector C (49P).
15. Disconnect the output shaft (countershaft) speed
sensor connector.
16. Turn the ignition switch to ON (II).
17. Measure the voltage between output shaft
(countershaft) speed sensor connector terminal
No. 1 and body ground.
*02
Is there about 5 V ?
YES
NO
−
14-114
OUTPUT SHAFT (COUNTERSHAFT)
SPEED SENSOR CONNECTOR
VCC1 (YEL/RED)
Wire side of female terminals
−
Go to step 18.
Go to step 27.
18. Turn the ignition switch to LOCK (0).
19. Disconnect PCM connector B (49P).
20. Check for continuity between output shaft
(countershaft) speed sensor connector terminal
No. 2 and body ground.
OUTPUT SHAFT (COUNTERSHAFT)
SPEED SENSOR CONNECTOR
NC (BLK/WHT)
Wire side of female terminals
Is there continuity?
YES
−
Repair short to body ground in the wire
between PCM connector terminal B38 and the
output shaft (countershaft) speed sensor, then go
to step 30.
NO
−
Go to step 21.
*03