Honda Accord 2008 Manual page 1321

07/11/02 09:20:23 61TA0000_170_0055
Power Steering
Steering Gearbox Overhaul (cont'd)
63. Hold the gearbox housing using a C-clamp (A) and
wooden blocks (B). Do not clamp the cylinder part
of the gearbox housing in the vise.
＊４１
64. Coat the inside surface of the cylinder end (A) with
power steering fluid, then install the cylinder end
by screwing it into the cylinder (B). Tighten the
cylinder end to the specified torque.
＊４２
65. Stake the point of the cylinder shown (opposite
from where the stake was removed during
disassembly).
17-54
B
2.0 mm
B
(0.08 in.)
1.0 1.5 mm −
(0.04 0.06 in.) −
A
98.1 N·m
(10.0 kgf·m, 72.3 lbf·ft)
66. Coat the new O-ring (A) with steering grease, and
carefully fit it on the valve housing.
A
Replace.
(08C35-B0534L)
A
67. Apply steering grease to the ball bearing (B) in the
gearbox housing, then install the valve body unit
(C) by engaging the gears. Note the valve body unit
installation position (direction of the line
connections).
68. Loosely install the flange bolts (D).
69. Install the cylinder line A and B to the steering
gearbox.
Note these items during reassembly:
• Thoroughly clean the joints of the cylinder lines.
The joints must be free of foreign material.
• Install the cylinder lines by tightening the flare
nuts by hand first, then tighten the flare nuts to
the specified torque.
17 N·m
(1.7 kgf·m, 12 lbf·ft)
D
C
B
(08C35-B0534L)
A
26 N·m
(2.7 kgf·m, 20 lbf·ft)
B
＊４３
＊４４