Countershaft Inspection - Honda Accord 2008 Manual

07/11/02 09:25:07 61TA0000_130_0045

Countershaft Inspection

1. Inspect the gear and bearing contact areas for wear
and damage, then measure the countershaft at
points A, B, and C. If any part of the countershaft is
less than the service limit, replace it.
Standard:
A Ball bearing contact area
(transmission housing side):
B Distance collar contact area:
C Needle bearing contact area
(clutch housing side):
Service Limit:
A: 29.97 mm (1.180 in.)
B:
C:
＊０７
− −
30.020 30.033 mm (1.1819 1.1824 in.)
39.937 39.950 mm (1.5723 1.5728 in.) − −
40.000 40.015 mm (1.5748 1.5754 in.) − −
39.88 mm (1.570 in.)
39.95 mm (1.573 in.)
C
B
2. Inspect the runout by supporting both ends of the
countershaft. Then rotate the countershaft two
complete turns while measuring with a dial gauge.
If the runout is more than the service limit, replace
the countershaft.
Standard:
Service Limit: 0.05 mm (0.002 in.)
A
ＴＡ０８ＡＥＡＥ３４１５０２０００００ＭＡＡＴ００
0.02 mm (0.001 in.) max.
13-45
＊０８