Honda Accord 2008 Manual page 1653

07/11/02 09:31:10 61TA0000_200_0086
Moonroof
Glass Weatherstrip Replacement
1. Remove the moonroof glass (see page 20-83).
2. Place a piece of masking tape (A) on the middle of
the front edge of the moonroof glass (B). Make sure
that the tape is on the glass only and not touching
the soft rubber of the weatherstrip.
＊０１
C
3. Place a mark (C) on the masking tape that aligns
with the seam (D) of the weatherstrip.
4. Push down on the top of the old weatherstrip with
your thumb until a small section separates from the
moonroof glass. Once a section has started to
separate, grip it and pull outward, working around
the moonroof glass until the weatherstrip is
completely removed (note the locations of the
holes in the weatherstrip).
20-84
B
A
D
5. Align the seam (A) of the new weatherstrip (B) to
the mark (C) on the masking tape (D). Make sure the
holes are pointed in the same direction as noted in
step 4.
B
A
D
C
6. Press the ridge of the new weatherstrip into the
groove on the moonroof glass where the masking
tape is marked. Work toward one corner; then go
back to the middle and work toward the opposite
corner. Be careful not to stretch the weatherstrip.
7. Continue pressing along one side, from corner to
corner; then press along the opposite side, from
corner to corner.
8. At the rear of the moonroof glass, continue
pressing from one corner to the middle; then press
from the opposite corner to the middle until the
strip is completely installed.
9. Reinstall the moonroof glass (see page 20-83).
10. Check for proper fit of the new weatherstrip by
opening and closing the moonroof.
ＴＡ０８ＡＢ９Ｊ３４２０００４０９２１ＫＢＡＴ００
＊０２