Honda Accord 2008 Manual page 1076

07/11/02 09:18:10 61TA0000_140_0233
A/T Clutch Pressure Control Solenoid Valve B Test
1. Connect the HDS to the DLC (A) located under the
driver's side of the dashboard.
＊０５
2. Turn the ignition switch to ON (II). Make sure the
HDS communicates with the PCM. If it does not, go
to the DLC circuit troubleshooting (see page
11-208).
3. Select Clutch Pressure Control (Linear) Solenoid
Valve B in the Miscellaneous Test Menu on the HDS.
4. Test A/T clutch pressure control solenoid valve B
with the HDS.
• If the valve tests OK, the test is complete.
Disconnect the HDS.
• If the valve does not test OK, follow the
instructions on the HDS.
• If the valve does not test OK, and the HDS does
not determine the cause, go to step 5.
5. Do the battery removal procedure (see page 22-90).
A
6. Loosen the two bolts located behind the battery
base, and remove the two bolts securing the
battery base, then remove the battery base.
7. Disconnect the A/T clutch pressure control solenoid
valve B connector.
8. Measure the resistance between A/T clutch
pressure control solenoid valve B connector
terminals No. 1 and No. 2.
Standard: 3 10 −
• If the resistance is within the standard, go to step
11.
• If the resistance is out of standard, replace A/T
clutch pressure control solenoid valve B
(see page 14-235).
9. Connect a jumper wire from the negative battery
terminal to A/T clutch pressure control solenoid
valve B connector terminal No. 2, and connect
another jumper wire from the positive battery
terminal to A/T clutch pressure control solenoid
valve B connector terminal No. 1.
• If a clicking sound is heard, the valve is OK. The
test is complete, reconnect the connector, then
go to step 19.
• If no clicking sound is heard, go to step 10.
ＴＡ０８ＡＥＢＥ１０４１０６１２２２３ＦＥＡＴ３０
＊０６
(cont'd)
14-231